Image

Gas Tracer Specifications

The product datasheet is available for download here (1.3MB).

Gas Detected
Combustible Gases
(Methane as standard)
% Volume
Methane
PPM
Methane
Oxygen (O2)
Carbon Monoxide (CO)
Detection Principle
Catalytic combustion
Thermal conductivity
MOS
catalytic
Galvanic cell
Electro- chemical cell
Detection Range
0 ~ 100% LEL
0 ~ 100% Vol.
0 ~ 5000
ppm
0 ~ 40% Vol.
0 ~ 500 ppm
Accuracy Statement
(whichever is greater)
± 5% of reading or
± 2% LEL
± 5% of reading or ± 2% of full scale
± 10% of reading or ± 50 ppm CH4
± 0.5% O2
± 5% of reading or ± 5 ppm CO
Sampling Method Internal sample pump, flow rate nominal 0.5 LPM, includes hydrophobic filter
Display Digital LCD with 7 segments, auto backlight during alarm
Preset Alarms
(User Adjustable)
1st alarm 10% LEL
2nd alarm 50% LEL
Over alarm 100% LEL
No alarms for
% Vol. CH4
Increasing tone/light pulse as concentration increases Low alarm 19.5% High alarm 23.5% Over alarm 40.0% 1st 25 ppm
2nd 50 ppm
TWA 25 ppm
STEL 200 ppm
Over 500 ppm
Alarms Types Leak Tracker Mode: Escalating audible/visual alarm, changes with gas level (audible can be turned off)
Gas alarms: 1st and 2nd, STEL, TWA (user adjustable) and OVER
Trouble alarms: Sensor connection, low battery, low flow, circuit trouble and calibration error
Alarm Methods Gas alarms: Flashing lights, two tone buzzer, and vibration
Trouble alarms: Flashing lights, trouble displayed, intermittent buzzer, and vibration
Operating Temp. & Humidity -20°C to +50°C (-4°F to 122°F)
0 to 95% RH, non-condensing
Response Time Within 30 seconds (T90)
Continuous Operation Alkaline battery: 15 hours Li-Ion battery: 10 hours
70°F (21°C)
Power Source Li-Ion battery pack, or 3 “AA” Alkaline battery pack; interchangeable
Safety Rating ATEX, TIIS, IECEx, CE,
c CSA us classified (pending), as intrinsically safe. Class I, Division 1, Groups A, B, C, D
Dimension & Weight Approx. 143 (H) x 71 (W) x 43 (D) mm (5.6” H x 2.8” W x 1.6” D), approx. 350 g (12.3 ounces)
Case Material High dust & water resistant design. RFI shielded high impact plastic with protective rubber overmolding
Controls Five buttons: POWER / ENTER, DISPLAY, AIR, RESET, SHIFT
Standard Accessories • Belt clip • Rubber nozzle, 2.5” • Datalogging software
• 10” Probe • Manual • Quick reference card
• 10’ Hose • Training CD
Optional Accessories • SDM-2012 calibration stations • Calibration kit
• Li-Ion battery pack • AC or DC Charger
• Sample draw hoses (10’ standard, up to 50’ max. available) • Carrying case
Configurations 1, 2, 3, 4, or 5 sensor units
Li-Ion or alkaline battery pack options
Warranty Two years material and workmanship